![]() ![]() Refer to the Supported Software and Tools section. Using application Makefile: To use large sector work flash add "EEPROM_LARGE_SECTOR_WFLASH" to DEFINES in application Makefile as shown below.Įm_EEPROM middleware can be used in various Development Environments such as ModusToolbox, Mbed OS, etc. To use Large sector work flash, uncheck this box. Using EEPROM Personality: The EEPROM personality has checkbox for: "Work Flash Sector Selection default Small Sector" which is "checked" by default. To use large sector work flash, the user can use EEPROM personality or edit application Makefile. The default assumes use of small sector work flash. The user should select which type of Work FLash region will be used for Em_EEPROM storage. ![]() The "Work Flash" provides sectors with 2 sizes namely: Large (2 kbytes) and Small (128 bytes). XMC7xxx and T2G-B-H based devices support Em_EEPROM Data only in "Work Flash". XMC7xxx and T2G-B-H Em_EEPROM storage restrictions The Quick Start Guide section highlights the use case, when the Em_EEPROM data is located in the application flash, and the Em_EEPROM is configured to increase the flash endurance (the wearLevelingFactor parameter is turned on). Refer to the Migration from PSoC Creator section. ![]() You may also want to migrate from PSoC Creator to ModusToolbox or other environment to simply use the Em_EEPROM middleware APIs. The Configuration Considerations section provides the guidance for all these operation modes and use cases. Note: refer to device capabilities for supported storage location for EM_EEPROM data.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |